I worked on the structural part of the upper case of the Seymour tambour desk.
The panels were so thin, I had to care fully plane them to fit in.
My smoothing plane was set up so that it could take shavings of 0.0015" thick in the middle, and 0.001" thick in its sides.
++
I glued up the gallery dividers without making a groove for the secret drawer and a key hole.
I worked it out any way by a specially made router. ;-)
+++
I made an arrow banding for the case top, which will be rip cut to finished banding next monday.
++++
I made a special tool for setting in petals of bell flower inlay.
No comments:
Post a Comment